Used WR284 tuner with round flange connections. This older vintage component is in good condition and is offered as a low-cost solution for microwave research. Unpainted aluminum waveguide body. Brass stubs with knurled locking nuts. Goods will be microwave tested prior to shipment. Photos provided upon request.
3-stub microwave impedance tuner with round flange connections. Photos available upon request.
Unpainted aluminum waveguide. Base model number is GA2301 with a (hard to read) suffix of -2-8.35 or perhaps -2-9.35. This elbow is elongated on one of the two sides. The other side is very short, possibly minimum length for a 90-degree design.
WR284 rectangular waveguide microwave power transition to N-type coax with nominally 1000W power handling capacity. Per the attached PDF, GAE offers a series of high power waveguide to coax transitions that deliver high performance at relatively high microwave power levels. Each model in the series utilizes the classical cross-bar method of terminating the coaxial center conductor, thus minimizing or eliminating the voltage breakdown common with non-terminated designs. The power rating is limited only by the rating of the coaxial cable (provided by the customer) attached to the Type N connector, which in most cases does not exceed 1 kW.
Used, in great condition. Intended for use at 55.0 dB coupling factor (forward and reflected). Waveguide length is nominally 5 inches port-to-port. Images can be provided upon request.
Water-cooled design, WR284 waveguide size, intended for 2.45 GHz use. Ceramic magnets look fine. Round-flange connections. Photos provided upon request.
